1.Rated power : 180 W
2.Working power: 230 V . AC 50 - 60 Hz
3.Max lifting force: 130 kg
4.Crown rotation speed: 10.5 rpm
5.Load reel speed: 8.5 rpm
6.Max lift height: 7 m
7.Working temperature: -20°C+50°C
8.Weight: 8 k g
DRILLING THE TUBE & ATTACHING THE OPERATOR
DRILLING THE TUBE
Drill the tube as shown . Hole 1 should be 30mm from the center of the
tube, and holes 2 and 3 300mm further down the tube as shown .
Through bolting is recommended for door weights over 300 lbs
ATTACHING THE OPERATOR
Remove the drive ring, Position the operator on the tube and slide the clamp on as shown below
ROUTING CABLES
Rout the power and brake e release cables through the prepared holes and
out the tube side away from the drive ring,as shown on the diagram below.
ELECTRICAL CONNECTIONS ** WARNING: TURN OFF POWER AT THE BREAKER**
Connect the central operator to the control device. A standard key switch is shown.
connect more than one operator to a single set of contacts, For other control options, contact SIMU After connecting the operator to the control. test the direction of rotation. If the operator turns in the wrong direction, reverse the red and black motor leads
BRAKE RELEASE
Follow the instructions supplied with the break release kit. Note, on the hanging
break release, you should never release the break by pulling on it. The The break is
released or engaged by screwing or unscrewing the hanging handle
ATTACHING THE DOOR/GRILLE：
Attach the door/grille as shown in the figures below. When using with 240mm band springs,
kit 400047 must be used
RAPID LIMIT ADJUSTMENT
1-Close adjustment knob
2-Close limit block
3-Close limit areas
4-Open limit areas open adjustment knob
5-Open limit block
6-Open adjustment knob
7-Close adjustment draining block
8-Open adjustment draining block
